Implant Dentistry Implant Dentistry
Implant Dentistry
.
Home Page
The Practice
Resources for our Patients
Resources for Dentists
Case Studies
Seminars for Dentists on Dental Explorations
Contact Us
Implant Dentistry
Visit the J. Morita USA, Inc. Web Site
Visit the Dental Explorations Web Site
Dr. Hoos' Upcoming Seminars on the Dental Explorations
NTI Web Site
OsseoNews

Esthetic Temporary Fabrication:
An Innovative Technique

By Dr. Jeffrey C. Hoos, DMD, FAGD
Raymond L. Bertolotti, DDS, PhD
As appeared in Contemporary Esthetics and Restorative Practice® January 2000

The current trend for chairside fabrication of temporary restorations is to use a cartridge-delivered temporary composite (Luxatemp®, Zenith Dental / DMG; 3MTM Iso-TempTM Temporary Material, 3MTM Dental Products; Turbo Temp, Danville Engineering). These composite materials have many advantages over traditional powder-liquid methyl methacrylates, including increased accuracy and speed. However, fracture resistance is a frequently encountered problem when using these cartridge-delivered composites. Therefore, we have developed a fast technique for making temporary restorations using conventional light-curing composites. These temporaries have dramatically increased fracture resistance.

This new technique offers enhanced esthetics as well as better mechanical properties. The technique requires only a clear vinyl poly-siloxane (VPS) impression material (Star VPSTM, Danville Engineering) (Figure 1); MemosilTM C.D., Heraeus Kulzer, Inc; or PolySil, SciCan USA) and any conventional, light-curing composite.

Figure 1
Figure 1. Clear Star VPSTM impression material.

Preliminary Impression

Before teeth preparation, a trayless technique is used to make the preliminary impression (Figure 2), and cheek retractors allow for great visibility. The clear VPS material is placed on the palatal aspect and moved to the buccal using an impression gun tip. The patient is asked to bite down and position the tongue on the roof of the mouth. This movement will immediately place the teeth in maximum intercuspation. This position, which will be molded in the preliminary impression, ensures that the patient's previous occlusion is reproduced. Before removing the cheek retractors to border mold the impression, ask the patient to use his or her tongue to gently guide the material toward the teeth. The patient's tongue and muscle movement makes for a well adapted and suitably thin impression. Ideally, the material should be kept thin; however, if it is thick, it is clear enough that light can pass through to cure the composite with extra curing time.

Figure 2
Figure 2. Preliminary impression in clear VPS using a trayless technique before teeth preparation.

Composite Placement Procedures

After teeth preparation (Figure 3), a slightly excessive amount of composite is placed into the preliminary impression (Figure 4). If the composite is stiff, place the syringe in warm water to lower the viscosity. The composite and tray is then seated over the prepared teeth and the patient is asked to gently bite the impression.

Figure 3
Figure 3. Completed teeth preparation.
Figure 4
Figure 4. Composite placed into the clear VPS impression.

While not necessary, the teeth may be disinfected and desensitized by placing MicroprimeTM (Danville Engineering) or Gluma® Desensitizer (Heraeus Kulzer, Inc.) over the prepared teeth before seating the composite (Figure 5). If desired, a water-based lubricant can be used to ensure bonding does not occur to the prepared tooth or to a previously placed composite.

Figure 5
Figure 5. Seating of composite filled VPS impression.



Home Page
Return to Main Page		 Continue
Continue



Brush and Floss Dental Center
Brush and Floss
 
info@bettersmile.com




Designed and Hosted by Sk Web Construction